![]() ![]() I opted to mount the external speaker on the extra space I had beside my windshield light switch located on the Daystar lower dash switch panel. I again routed the power cable from the CB box to the center of the dash following existing wires, securing them along the way with zip ties. I hooked the hand mic up to the CB unit and ran the mic cable under the dash, securing it along the way to existing wiring with zip ties.īefore re-installing the glove box, I hooked up an external speaker which also came in the kit. This is very easy to install and come with instructions that are easy to read and understand. I opted, at the advisement of a few members here on WAYALIFE, to use the Cool Tech CB hand mic mount. I then hooked the power wire directly to the battery so that I have the option to use the CB even if the vehicle is not on or running. ![]() ![]() Once I made a passage, I then taped the red power wire to the coat hanger and ran it with the power wire through the same passage I just made. To do that, I used a thick wire coat hanger to punch a hole through the spray foam that whether proofs the hole. The power wire or ‘hot’ wire I ran through a small hole that goes through the firewall and comes out just under the cowl when the hood is open. I opted to ground the black wire to an already existing blot located just underneath the panel. There is a small area where you can do this located under the passenger side dash panel. The ground and power wires I ran through the passenger side of the Jeep. I opted to mount the CB to the Jeep using some strong zip ties rather than drilling into anything under the dash. With the glove box open, just push the sides of the glove box inward and lift up. I then mounted the CB receiver/transmitter underneath the glove box. From there, I ran the coax under the rear cargo trim and under the carpet, following the wiring harness along the passenger side, all the way to underneath the dash. I zip tied the coax to the wire loom that is already running through it. I ran the coax cable through the tailgate vent and behind the plastic cover on the inside of the tailgate. This mount works great with the EVO MFG GatePlate, as seen below. Weird, I know! I first mounted the Firestick Antenna to a center mounted Full Metal Fabworks antenna mount. You can find the package here: Īdmittedly, I worked my way from back to front. I ordered mine as a kit with coax cable and 4’ Firestick antenna from Northridge 4x4. Choose normal CB channel readout or five digit frequency display.Just a quick write-up for those of you considering the Cobra 75WXST CB. Instant access to information Channel 19 with a single switch of a button.Īll the information you need is provided from this LCD display panel. Full Channel Scan allows you to scan all 40 channels. Remote installation box installs out of sight under your dash and the quick disconnect allows removal of the hand piece for security or use in other vehicles.ĭual Watch allows simultaneous monitoring of any two preselected channels. 10 National Weather Channels (7 NOAA and 3 International) provide full coverage to keep you informed of weather conditions anywhere you go. Complete access to all 40 Citizen Band Radio channels. The result is a cleaner, clearer sounding CB with more "powerful" transmissions and less static or noise on reception.ġ0 Weather Channels. 40 channels, remote mount, Soundtracker, 10 NOAA weather channels, Dual Watchĭramatically improves the transmission and reception of CB radio signals. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |